Use Winter to for Preventive Maintenance
on Your Sprayers
Ric Bessin, UK Extension Entomologist
As winter begins to wind down, we need to get our equipment ready for the coming growing season. When it is time to begin spraying and planting, we don’t want to spend precious time to fix and repair equipment. It is during this down time when we should do some routine maintenance on our sprayers. Spray equipment in poor repair can lead to poor application which will cost you money.
Look for Leaks
Before your start, put on a pair of gloves to protect yourself from pesticide residues. Begin by filling your sprayer with clean water, but before you engage the pump, look for leaks from around the pump, hoses, strainers, and nozzles. Pay particular attention to the hoses, as these often show signs of wear sooner than other more durable parts. Besides obvious leaks from hoses, inspect hoses for cracking and signs of dry rot as these can burst when pressurized. Places where hoses might crimp with folding booms are prone to cracking as hoses age. Engage the pump and look again for leaks. Check the pressure gauge and test the cutoff valves to be sure they are working.
The job of strainers is to keep gunk from reaching and plugging nozzles. With just routine use there can be significant debris buildup with the inline strainer from the tank or the individual strainers in front of each nozzle. Sometimes these can be cleaned with a soft brush, other times they need to be replaced.
Next, the Nozzles All nozzles wear over time. This leads to increasing and irregular flow rate from nozzles and poor spray patterns. In place of uniform applications across a field, there may be streaks due to places of over and under applications. While some nozzles materials, such as ceramics and stainless steel, may be more resistant to wear, all nozzles will show signs of wear eventually. Sprays containing abrasive materials such as wettable powders and flowables cause more wear to nozzles. Before conducting a catch test, be sure each of the nozzles are of the exact same type and are not mismatched. Start your sprayer with the clean water and observe the pattern from each of the nozzles, look for streaks and clogs. The pattern from each nozzle should be the same. Run a 30-second or 1-minute catch test for each nozzle, output from each nozzle should be within 5% of the average output from all nozzles. Nozzles that are worn or cannot be unclogged need to be replaced and the catch test repeated.
Now that your sprayer is working properly, it needs to be recalibrated. As new strainers and nozzles can change the spray output. Calibration should be done at a minimum once a year, but for those that use a sprayer more frequent or after changing to different nozzles (going from flat fan to hollow cone for example) recalibration must be done more often. For instructions for calibrating a sprayer are in the Recordkeeping Manual for Private Pesticide Applicators.
Posted on February 27, 2023, in Uncategorized and tagged Agriculture, University of Kentucky Cooperative Extension Service, warren county agriculture. Bookmark the permalink. Leave a comment.
Leave a comment